Haier XPB55-12S User Manual - Page 5

Using process Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). Water level adjusting lever Corrugation Pipe 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. Figure 1 4. Install the overflow filter. (1),Install the corrugation pipe. (2),Insert the mounting plate at the bottom of the filter into the valve cover. (3).Hang up the hook at the left upper side. (4).Push the upper part in as indicated in Figure 2. Hook Figure 2 Disposal of the complete unit • Wipe the complete unit with soft cloth twisted dry. • Wipe with neutral detergent if too dirty • Do not wash it directly by water • After washing, dismount the water inlet hose. • Do not store water in the tub for long period. Discharge the water immediately after each using. • Pull off the power plug and hang up the power cord. • Hang up the drain hose. • Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub and the inner/outer cover of the spin tub for some time (about one hour), then close them. 14 Installation and adjustment Before Using Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose 1 The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.