Haier XPB58-113S User Manual - Page 7

How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Soft item Extend the drain hose from the side of spin tub Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Take the hose out of the fixing groove. (See to Figure 2). Embed the drain hose into the groove along the side of the spin tub in the order of (1)~(3), heading Soft item for the side of the spin tub. (See to Figure 3). Back Front Figure 1 Figure 2 Embed the drain hose into the groove with hands. Take care not to damage the drain hose in fastening the fixing clamp. Extend the drain hose from the rear side Extend to the spin tub side Take out the drain hose from the fixing groove. Extend it fromthe rear side as per the direction of the arrow. (When the drainhose is extended from the rear side, it can be hung on the point for drain hose at the two sides of the cabinet.) (See to Figure 4). Embed into the groove in turn Figure 3 Figure 4 Install the water inlet hose; Select the water level Insert the water inlet hose into the Water inlet hose water-filling entrance, then push the water-filling jointer into the wash Push Control handle Water-filling jointer Wash water-filling entrance water-filling entrance on the major frame.(To dismantle the water inlet pipe, just push the control handle as indicated in the figure and pull it out) Select water level according to the quantity of the laundries. Set the water level adjusting lever to needed line. Water level indicator Maximum Max about 43L Medium about 36L Minimum about 30L Med Min 5