Hamilton Beach 33967 Use & Care - Page 12

840161402 ENnv03.qxd 11/30/07 9:50 AM Page 12 Troubleshooting POTENTIAL PROBLEM PROBABLE CAUSE There is no display visible on the control panel. • Is the unit plugged in? • Is the unit turned on? Display should flash SEL. • Test that the electrical outlet is working with a lamp in known working order. • Power interruption of 5 seconds or longer. I can't program the current time on the control panel. • There is no "clock" feature on this slow cooker, only a countdown timer. Food is undercooked. • Was food cooked on the Warm setting? Do not cook on Warm setting; always cook on Low or High heat settings. • Was power interrupted (due to brownout, electrical storm, etc.) for 5 seconds or longer? NOTE: For a power interruption of 5 seconds or less, the slow cooker will remember the programmed heat and time settings. • Did you select the Low heat setting, but used a cooking time based on the High heat setting? • Did you have the Glass Lid placed correctly on the slow cooker? The food isn't done after cooking the amount of time recommended in my recipe. • This can be due to voltage variations (which are commonplace everywhere) or altitude. The slight fluctuations in power do not have a noticeable effect on most appliances. However, it can alter the cooking times in the slow cooker by extending the cooking times. Allow sufficient time and select the appropriate heat setting. You will learn through experience if the shorter or longer time needed. My meal was overcooked. Why? • Was the crock at least half-full? The slow cooker has been designed to thoroughly cook food in a filled crock. If the crock is only half-filled check for doneness 1 to 2 hours earlier than recipe time. • Did you select hours based on a Low heat recipe? • Foods will continue to increase in temperature after desired temperature has been reached. 12