Harbor Freight Tools 63061 User Manual - Page 4

Safety Setup Air Source 1. Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool may cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated air‑pressure range. 2. Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons. SAVE THESE INSTRUCTIONS. Symbols and Specific Safety Instructions Symbol Definitions Symbol Property or statement no No-load speed .../min Revolutions or reciprocation per minute PSI Pounds per square inch of pressure ft-lb Foot-pounds of torque BPM Blows per minute CFM SCFM Cubic Feet per Minute flow Cubic Feet per Minute flow at standard conditions Symbol Property or statement NPT National pipe thread, tapered NPS National pipe thread, straight WARNING marking concerning Risk of Eye Injury. Wear ANSI‑approved eye protection. WARNING marking concerning Risk of Hearing Loss. Wear hearing protection. WARNING marking concerning Risk of Respiratory Injury. Wear NIOSH‑approved dust mask/respirator. WARNING marking concerning Risk of Explosion. Operation Maintenance Page 4 For technical questions, please call 1-888-866-5797. Item 63061 62835