Harbor Freight Tools 65345 User Manual - Page 9

Unpacking When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. To prevent serious injury from accidental operation: Turn the Power Switch (46) of the Lathe to its "OFF" position and unplug the tool from its electrical outlet before assembling or making any adjustments. PRODUCT FEATURES BALANCE WHEEL (22) HEADSTOCK SPINDLE (14) FIGURE A TAILSTOCK (5) BACK LID (20) HEADSTOCK SPUR CENTER (12) LOCK LEVER (6) TOOL REST (35) CUP CENTER (11) TAILSTOCK HANDWHEEL (4) BED SLIDE LID (63) BED (1) SWITCH (46) ASSEMBLY Instructions Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. 1. The Lathe comes fully assembled with the exception of the Tool Rest (35). To install the Tool Rest, loosen the Lock Lever (41). Insert the Tool Rest into the Tool Rest Base (36). Then retighten the Lock Lever to secure the Tool Rest in place. (See Figure B.) TOOL REST BASE (36) TOOL REST (35) FIGURE B LOCK LEVER (41) Work Area Set Up 1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent injury and distraction. SKU 65345 For technical questions, please call 1-800-444-3353. Page 9