Harbor Freight Tools 69719 User Manual - Page 13
Loading the Tool, General Operating Instructions
View all Harbor Freight Tools 69719 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SAFETy SETUp Loading the Tool TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION, BEFORE LOADING: • Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields. • Release the trigger. • Detach the air supply. • Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners. 1. Only use the proper size and type of staple with this tool. 2. Press down on the Magazine Release to open Magazine. Open the Magazine completely. 3. Place a full clip of staples inside the Magazine so the pointed ends of the staples are directed away from the tool. 4. Keep fingers clear while sliding the Magazine closed until it clicks shut. General Operating Instructions 1. Before each use, test the tool as directed in the prior section. 2. If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use. WARNING! TO pREVENT SERIOUS INJURy: Keep second hand away from tool discharge area, especially if holding workpiece. Tool applies extreme force to fastener, and fasteners may deflect or fire in an unexpected direction. cAUTION! TO pREVENT INJURy: Do not hold tool near body while firing. Tool recoil can cause injury. 3. Rotate Air Deflector to redirect exhaust air away from you. 4. Position tool at desired fastener location and depress the Safety Nosepiece fully against the workpiece. Squeeze the trigger to fire a fastener. 5. If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this tool. cAUTION! TO pREVENT INJURy FROM TOOL OR AccESSORy FAILURE: Do not exceed the tool's maximum air pressure rating. If the tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required. 6. After use, to prevent accidents: a. Release the trigger. b. Detach the air supply. c. Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners. d. Release the trigger again. e. clean external surfaces with clean, dry cloth. f. Store indoors out of children's reach. OpERATION MAINTENANcE Item 69719 For technical questions, please call 1-800-444-3353. Page 13