Harman Kardon AVR 230 Owners Manual - Page 35

PROGRAMMING THE REMOTE

PROGRAMMING THE REMOTE

35

Resetting the Remote Memory

As you add components to your home theater system,

occasionally you may wish to totally reprogram the

remote control without the confusion of any commands,

macros or ”Punch-Through“ programming that you may

have done.To do this, it is possible to reset the remote

to the original factory defaults and command codes by

following these steps. However, once the remote is

reset, all commands or codes that you have entered will

be erased and will need to be reentered:

1. Press any of the

Input Selector Buttons

e

and

the

”O“ Button

r

at the same time until the

Program/SPL Indicator

c

begins to flash amber.

2. Press the

”3“ Button

r

three times.

3. The red LED under the

Input Selector

e

will go

out and the


c

will stop

flashing and turn green.

4. The


c

will remain green

until the remote is reset. Note that this may take a

while, depending on how many commands are in the

memory that need to be erased.

5. When the


c

goes out,

the remote has been reset to the factory settings.

Harman Kardon AVR 230 Owners Manual - Page 35

Resetting the Remote Memory

Page 35 highlights