Harman Kardon AVR 245 Owners Manual - Page 30
Initial Setup - user manual
View all Harman Kardon AVR 245 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
INITIAL SETUP Before you begin enjoying your new receiver, a few adjustments should be made to configure the AVR 245 to match your actual system. Make sure that you have connected a video display to either the S-video or composite video monitor output on the receiver. When you turn on your display and the AVR, you should see a blue screen. A message may appear briefly at the bottom of the screen. This message is part of the on-screen display system, and is referred to as the "semi-OSD". The semi-OSD is activated any time you send a command to the AVR, and any time the AVR detects a change in the incoming signal. Semi-OSD messages are overlaid on top of any video signal, so that you may continue to watch your program while making adjustments to the AVR. Although it's possible to configure the AVR using only the remote and the semi-OSD messages, we recommend that you use the full-screen menu system, known as the "full OSD". Using the On-Screen Menu System The full-OSD system is accessed by pressing the OSD Button on the remote. See Figure 40. While the full-OSD system is in use, it isn't possible to see any video programming. In addition, an OSD ON message will appear on the front panel of the receiver to remind you to use a video display. Figure 40 - Navigation Buttons The Master Menu will always be displayed when you first press the OSD Button. Use the ⁄⁄¤ Buttons on the remote to point the cursor to different lines in the menu. Press the Set Button on the remote to select a line that has no setting to be adjusted, such as one of the submenus listed in the Master Menu, or a line that returns you to a previous menu. Within the submenus, after you have positioned the cursor at a particular line item, you will need to use the ‹/› Buttons on the remote to change a setting. When the desired setting appears, use the ⁄⁄¤ Buttons to navigate to another line item. Except for the TITLE setting in the INPUT SETUP menu, there is no need to press the Set Button after your desired setting appears. NOTE: The ‹/› and Set Buttons on the front panel have no effect on the OSD system. The Master Menu allows access to six submenus: Input Setup, Surround Select, EzSet+, Manual Setup, Multi-room and System Setup. See Figure 41. Figure 41 - Master Menu Screen If you are an experienced home theater user, you may prefer to use the menus in this order: 1. System Setup (described in Advanced Functions section) 2. EzSet+ (described in this section) 3. Manual Setup (described here and in Advanced Functions) 4. Input Setup (described in this section) 5. Surround Select (see Advanced Functions section) 6. Multi-room (described in Advanced Function section) We recommend that most users follow the instructions in this INITIAL SETUP section to configure a basic home theater system. You may return to these menus at any time to make additional adjustments. This section requires that you complete all of the steps in the Installation section that apply to your receiver. You should have connected all of your loudspeakers and a video display, as well as your source devices. You should be able to turn on the receiver and view a blue screen on your video display. If necessary, reread the Installation Section before continuing. Configure the AVR 245 Using EzSet+ One of the most important and perhaps often overlooked aspects of setting up a home theater system is to calibrate the receiver to match the loudspeakers, which enables the AVR to perform at its best. Until recently, most receivers required the user to perform the calibration and configuration manually, a somewhat tedious process that called for a good ear or the purchase of an SPL (sound-pressure level) meter. Although you may configure the AVR 245 manually, as described in the Advanced Features section, we recommend that most users take advantage of our signature EzSet+ system. 30