Harman Kardon CH140 Owners Manual - Page 11
Controls, Indicators
View all Harman Kardon CH140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Mono Mode : All FM broadcasts will be received as monaural broadcasts, regardless of whether or not they are in stereo. This mode may provide quieter, more listenable sound quality under poor reception conditions. Auto Mode : FM stereo reception is automatically selected when received at medium or high signal strength. When an FM monaural signal or a weak FM stereo signal is received, it automatically switches to the FM monaural mode. 12. SEEK Button Push left side of this button to operate SEEK function. (Refer to the "TUNER" section.) 13. TUNING (DOWN/UP)/CLOCK (Minutes/Hours) Button Use this button for manual tuning. UP : When this side is pressed, the tuner frequency increases. DOWN : When this side is pressed, the tuner frequency decreases. In FM mode, frequency display moves in 200* kHz steps. In AM, the display moves in 10* kHz steps. If this button is pressed for more than a second, the display moves quickly and continuously until released. This button also controls the hours and minutes displayed on the clock. To set the clock time hold down the memory button an simultaneously push the up and down buttons. The up button sets hours, the down button minutes. CONTROLS & INDICATORS 14. 70 µSEC (Tape Selector) Switch/LOCAL-DX Selector Press when using metal or CrO2 tape. This is also the LOCAL-DX Selector during tuner operation. Press this button to change the mode. 15. FM/AM Band Select Switch 16. PRESET MEMORY Buttons Press any one of the six Preset Memory buttons while the channel indicator blinks, and the frequency displayed is memorized at that Preset Memory button. Each position can memorize one frequency in both FM and AM bands. Once a station frequency is memorized, it can be recalled any time the same button is pressed. 17. MEMORY Button This button is used to enter or change the preset broadcast stations. When this switch is pressed, the channel indicator blinks for 8 seconds. This indicates the preset memory standby state. This button is also used to change the display mode from FREQUENCY to CLOCK in the TUNER operation. NOTE : Figures indicated with * are changed except in North America to 1 00 kHz and 9 kHz respectively. 10