Harman Kardon D200 Owners Manual - Page 2
Antenna, Connections, Power, Phonograph, Auxiliary, Inputs, Recording, Automatic, Frequency, Control
![]() |
View all Harman Kardon D200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
ANTENNA CONNECTIONS AM The Harman-Kardon ceramic loop stick built into the Recital comprises all the antenna required for the finest in noise -free local AM reception. In locations more removed from metropolitan areas, an outdoor antenna may be required. This should consist of a single wire, as long as is reasonably practical, located away from large metal objects, power lines, or electrical machinery. Connect one end to the "AM" terminal of the "ANTENNA" terminal strip on the rear of the chassis. FM Due to the extremely high FM sensitivity of the Recital, the 48" wire furnished will be sufficient antenna for all but the most difficult locations. One end of the wire should be connected to the "FM" terminal of the "ANTENNA" terminal strip, the other end being left free and extended as may be convenient. In remote locations, a standard roof -top dipole and suitable twin leadin wire may be used, connected between the "FM" and "G" terminals. POWER CONNECTIONS If your music system is limited to AM and FM radio reception, all that is now necessary for operation is to plug the power cord into any outlet furnishing 117 volts, 60 cycles house current. The exact voltage is relatively unimportant, and may vary between 105 and 125; be sure, however, that you have 60 cycle AC power. For your convenience, the power cord of the Recital has been made extra long. An auxiliary AC receptacle is incorporated on the chassis to furnish power to an associated device, such as record changer, tape recorder, etc. PHONOGRAPH CONNECTIONS Any type of record player will operate with the Recital. To derive maximum enjoyment it is suggested that a high quality pickup cartridge and a rumble-free turntable be used. Two classes of pickup cartridges are in general use: Magnetic (GE, Pickering, Clarkstan, Fairchild, and Audak) and Crystal (including the newly developed ceramics). While any type of cartridge may be used with the Recital, it is strongly urged that the magnetic type be selected. It should be plugged into the receptacle marked"PH0N0". Connect crystal or ceramic cartridges to the receptacle marked "AUX". A word of advice: The useful life of a phonograph needle is quite short, ranging from 15 minutes to several hours. In addition to degradation of tone quality as the needle wears, the strong possibility exists that valuable records will be damaged if worn needles are not promptly replaced. The purchase of a diamond, which has very long life, is therefore a worthwhile investment. The power cord of the turntable may be plugged into the auxiliary outlet on the rear of the Recital chassis. It is sometimes advisable to ground the phonograph chassis to the receiver, to reduce hum or other unwanted noises. This may be accomplished by the use of any type of wire, one end connected to the "G" terminal of the "ANTENNA" or "SPEAKER" terminal strips, the other end connected to the metal framework of the phonograph. AUXILIARY INPUTS An input receptacle marked "AUX" is located on the rear of the Recital chassis. Any auxiliary equipment, such as a tape recorder or television tuner may be connected to this receptacle and can then be played through the fine audio system of the Recital. TAPE RECORDING A receptacle marked "DET" is located on the rear of the Recital chassis. This is used to provide output toa tape recorder or other auxiliary equipment. Any program material, whether AM or FM radio, phonograph, etc. , appearing at the "SPEAKER" terminals also appears at the "DET" receptacle, but unmodified by the volume and tone controls. This makes it possible to record programs with the proper recording equalization (as determined by your tape recorder). AUTOMATIC FREQUENCY CONTROL (AFC) FM Broadcasting, by its very nature, eliminates almost all natural and man-made static. However, the characteristics of FM which makes this possible also make for problems in tuning. The Harman-Kardon Recital incorporates an effective Automatic Frequency Control (AFC) circuit that overcomes these problems and insures proper tuning even if the manual tuning is not accurately done. The following experiment will lead to an understanding of AFC, and the fuller enjoyment of the Recital. First, tune across the FM scale. Note how the stations "pop" into place, one after the other. Now tune to any station, preferably one with a musical program. Press the tuning knob in to defeat the AFC, and tune slowly through the station from left to right. Notice that there are three points where the station sounds clean, interspersed with points of distorted sound. The middle clean-sounding point is the proper tuning position for the best tone quality with minimum noise and interference. Withthe knob pressed in, tune slightly away from the proper tuning position, until the sound is distorted. Release the tuning knob to reactivate the AFC, and notice how the sound clears up, as if the receiver had been manually retuned. Actually, the tuning has been readjusted by the operation of the AFC circuit, which automatically retunes the electronic circuits to the center of the station channel. The AFC circuit of the Harman-Kardon Recital performs the further function of overcoming any tendency of the tuner to drift. In order to take maximum advantage of the benefits of AFC, it is suggested that fine tuning be done with the knob pressed in, so that the center clean response point can be located. When the knob is released
![](/manual_guide/products/harman-kardon-d200-owners-manual-6334d97/2.png)