Harman Kardon DPR 1005 Owners Manual - Page 5

FRONT-PANEL CONTROLS ( *& ^ %$ # 12 A 34 5 67 B CDE F 89 ) G HJ IK !@ NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at www.harmankardon.com. The following controls and indicators are available on the DPR 1005's front panel: 1 Standby/On Indicator 2 Standby/On Button 3 Surround Mode Group Selector 4 Surround Mode Selector 5 Tuning Selector 6 Tuner Band Selector 7 Preset Station Selector 8 Input Source Selector 9 Tuning Mode Selector ) Set Button ! ¤/⁄ Buttons @ Front-Panel Control Door # Volume Control $ Input Indicators % Speaker/Channel Input Indicators ^ Upper Display Line & Lower Display Line * Surround Mode Indicators ( Remote Sensor Window The following controls and jacks are located behind the front-panel door. To open the door, press the center of the door and gently swing it down towards you. A Main Power Switch B Tone Mode Button C Speaker Selector Button D Channel Adjust Selector E Digital Input Selector F Delay Adjust Selector G Headphone Jack H Optical 3 Digital Input I Input/Output Indicator J Coaxial 3 Digital Input K Video 5 Audio/Video Jacks 1 Standby/On Indicator: This indicator is amber when the DPR is in the Standby mode to signal that the unit is connected to an AC power source and is ready to be put into operation. When the unit is in use, the indicator turns blue. 2 Standby/On Button: When the Main Power Switch A is "ON," press this button to turn on the DPR 1005; press it again to turn the unit off. 3 Surround Mode Group Selector: Press this button to select the top-level group of surround modes. Each press of the button will select one of the surround mode categories. Once the button is pressed so that the name of the desired surround mode category appears in the on-screen display and in the Lower Display Line &, press the Surround Mode Selector 4 to cycle through the individual modes available. For example, press this button to select Dolby modes, and then press the Surround Mode Selector 4 to choose from the various mode options. 4 Surround Mode Selector: Press this button to select from among the available surround mode options for the surround mode category selected. The specific modes will vary based on the number of speakers available, the surround mode category and whether the input source is digital or analog. For example, press the Surround Mode Group Selector 3 FRONT-PANEL CONTROLS 5