Harman Kardon HK3250 Owners Manual - Page 9
Operation - stereo receiver
View all Harman Kardon HK3250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
HK3250 engelsk 11/01/98 14:28 Side 7 ENGLISH Operation BASIC OPERATION 1 Press the POWER button to turn the power ON, the display panel will then light up. • When using the POWER button on the remote control turn the unit off, the unit will go into STANDBY mode. 2 Select the desired program source with the INPUT FUNCTION SELECTOR buttons and the selected input function appears in the display. 3 When the TAPE MONITOR button is set to ON so that the TAPE indicator lights up, the selected program source cannot be heard from the speakers. To listen to a program source other than cassette deck be sure to set the TAPE MONITOR button to OFF. 4 Adjust the volume to a comfortable listening level with the VOLUME control or VOLUME UP/DOWN buttons on the remote control. 5 For private listening, insert a 1/4 inch plug of the headphone into the HEADPHONE jack. • When the headphones are plugged, sound from the speakers is cut off. LISTENING TO BROADCASTS You can use auto, manual or preset tuning to select a radio station. AUTO TUNING If broadcast signals are strong and there is no interference, auto tuning is possible. 1 Press the FM or AM button to select the desired band. 2 Press the SEEK STEREO button and AUTO will illuminate in the display. 3 Press the TUNE UP/DOWN button. Tuning will start automatically and stop at a broadcast station frequency with sufficient signal strength. MANUAL TUNING Auto tuning may be impossible if the broadcast signal is weak. If so, use manual tuning. 1 Press the FM or AM button to select the desired band. 2 Press the SEEK/STEREO button and AUTO will go out in the display. 3 Press the UP or DOWN TUNE/PRESET button until the desired station frequency is reached. • Each time the button is pressed, the frequency changes by a step. • When the button is kept pressed, the frequency changes continuously in sequence. PRESET TUNING The receiver has a memory for up to 30 preset stations. If the station frequencies are stored in this memory, they can be tuned in by a simplified procedure. MANUAL PRESETTING Up to 30 stations can be preset at random, regardless of the reception band. 1 Tune in the station to be memorized using the auto or manual tuning. 2 Press the MEMORY button, then the MEMORY indicator lights up for 5 seconds. 3 Select the channel number with the UP or DOWN TUNE/PRESET NUMERIC buttons on the remote while the MEMORY indicator is lit, then the selected channel number lights up. 4 Press the MEMORY button to memorize the station. • When using the NUMERIC buttons on the remote, the station is memorized without pressing the MEMORY button again. • When selecting one digit channel number with the NUMERIC buttons, press the corresponding number without "0". 5 Repeat steps 1 to 4 to preset other stations. 7