Harman Kardon HKTS 12 Owners Manual - Page 11

Dolby Pro Logic* (Non-Digital) - Line Level USE THIS INSTALLATION METHOD FOR DOLBY PRO LOGIC APPLICATIONS (NOT DOLBY DIGITAL, DTS OR OTHER DIGITAL PROCESSING), WHERE THE RECEIVER/ PROCESSOR IS EQUIPPED WITH A SUBWOOFER OUTPUT, OR A VOLUME-CONTROLLED PREAMP (LINE-) LEVEL OUTPUT: Use the supplied RCA-type patch cord to connect the line-level subwoofer output on your receiver or amplifier to either the left or right Line-Level Full-Range Input ¢ on the SUB-TS12 subwoofer. Use both the left and right inputs on the subwoofer if your receiver or processor has both left and right line-level outputs. If your receiver is equipped with line-level outputs but does not have a separate subwoofer output, use a Y-adaptor (not supplied) to bridge the receiver's preamp output to the main amp input for that channel, and connect the long end of the adaptor to the corresponding line-level input on the SUB-TS12. IMPORTANT: Do not use the SUB Input £ on the subwoofer with Dolby Pro Logic processors. Make sure that you have configured your surround sound processor for "Subwoofer On." The front left, front right, center and surround speakers should all be set to "Small." When all connections have been made, plug the AC power cord on the subwoofer into an AC outlet. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier. SPEAKER CONNECTIONS Front Left - + Center - + SUB-TS12 Subwoofer Line-Level L R Front Right - + Surround Left - + Front Left Surround Left SUB/LFE Out Center Receiver Front Right Surround Right Surround Right - + SPEAKER CONNECTIONS 11