Harman Kardon SC3 Owners Manual - Page 3

The rear panel surface of the receiver has been designed as a heat sink (a device which dissipates heat) for the output transistors. This area will become warm under normal use. This is normal and should not be cause for concern. POWER REQUIREMENTS Connect the AC line cord into any outlet furnish- ing 117 volts, 50 or 60 cycle AC current. The voltage may vary between 105 and 125 volts. An AC convenience outlet is located on the rear panel of the receiver. This outlet is "switched" and is controlled by the on/off switch on the front panel. Any auxiliary equipment may be plugged into 'this outlet. The rating of this equipment should not exceed 200 watts. CONNECTING THE SPEAKERS FOR STEREO OPERATION A 24 foot speaker cable has been supplied with each speaker to connect to the receiver. Each end of the cable comes with a convenient molded plug for easy installation. It may be easily dressed around the molding for REAR PANEL ANTENNA FM 30011 TAPE/AMP AUX TAPE OUT CAUTION HIGH VOLTAGE INSIDE THIS UNIT HAS NO USER SERVICEABLE PARTS AND SHOULD BE SERVICED BY QUALIFIED TECHNICIAN ONLY GI UG HARMAN KARDON INC PLAnonEw , N.Y. MODEL SC3 MADE IN USA o • LEFT SPEAKER RIGHT SPEAKER SPEAKERS 4-8-ICIa '4* -p CLASS 2 WIRING ACCEPTABLE LEFT RIGHT AUXILIARY AC POWER OUTLET yL II? VAC 200W SWI-THED 11:1 ffl 50 IITVAC FUSE I.5A- LEFT INPUT CABLE RIGHT CABLE LEFT OUTPUT CABLE RIGHT INPUT CABLE STEREO TAPE RECORDER GROUND SCREW TERMINAL STRIP 3 LINE CORD FUSE