Harman Kardon TU910 Owners Manual - Page 5
Connections
View all Harman Kardon TU910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Connecting to an Integrated Amplifier or Preamplifier Connect the OUTPUT jacks of this unit and the TUNER or AUX input jacks of the preamplifier or the integrated amplifier by using the attached connection wire. Carefully connect the plugs to the left and right channel jacks. Push the plugs in all the way. Poor seating of the plugs tends to cause hum or intermittent sound and may damage the speakers. This unit is equipped with FIXED and VARIABLE OUTPUT jacks. The output level of the VARIABLE OUTPUT jacks can be adjusted in the range of 0- 0.775V (100% FM modulation) by using the LEVEL control on the rear panel. Adjust the LEVEL control so that the sound level from the tuner is the same as the sound level from other sources, such as phono or tape. CONNECTIONS NOTE: While you are connecting this unit to the rest of your high fidelity system, please unplug the power cord, disconnecting not only this unit but all the components from the AC outlet. Do not interwind the connection wires with the power cord. If interwound, the sound quality may be degraded. The AC convenience receptacle on the rear panel can be used for supplying power to a turntable, tape deck or other low power component. The power capacity is 100 watts. Check the component's owner's manual to find its power requirement. This outlet is independent of this unit's power switch. 750 coaxial cable FM outdoor antenna 30052 parallel feeder Accessory antenna AM outdoor antenna • AR AM loop antenna INPUT TUNER L:=7- To AC outlet RIO Integrated amplifier or preamplifier