Hayward AQ-SOL-LV-TC Operation Manual - Page 7

INSTALLATION Mounting The Aqua Solar is designed for outdoor use. Mount the enclosure vertically with the knockouts facing downward. For safety, the Aqua Solar must be a minimum of 5 feet (horizontally) from the pool or spa. Power input Turn off power at circuit breaker before wiring. Follow NEC and all local electrical codes. Wire to either 120VAC or 240VAC per the diagram below. If the Aqua Solar is being powered from the same circuit as one of the pumps, wire to the relay first and then jumper over the Aqua Solar terminal block. Do NOT use the Aqua Solar terminal block as a junction for pump power, the terminal block is not rated for high amps. Be sure to connect the earth ground to the green terminal. Fuse (2A, Slo-Blo) Relay Control Outputs Booster Pump Pool Sweep (heater interlock for -SP model) Filter Pump Rev Fwd } Valve Output Solar Pool Aux Input Power 120VAC 240 VAC Ground Cooling Recirculate/ Freeze Protection Celsius/ Fahrenheit Solar Override Temperature Sensor Inputs Output wiring to solar diverter valve Most installations use a solar valve, which diverts water through the collector panels when solar heat is available. For Hayward, Jandy, and Compool valve actuators (with wire end connectors), two 3-pin connectors are supplied. Plug the actuator into one of the Aqua Solar's two 3-pin connectors (see diagram above for location of connectors). If the valve operates opposite to the way it is supposed to, disconnect and plug into the other connector. 4