Hayward AQ-TROL-HP Models: AQ-TROL-HP AQ-TROL-HP-TL AQ-TROL-RJ and AQ-TROL-RJ- - Page 15
Bonding, Pump Output, Electrolytic Cell and Flow Switch
View all Hayward AQ-TROL-HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Bonding A lug used for bonding is attached to the bottom of the Aqua Trol enclosure. Connect to the pool bonding system using minimum 8AWG copper wire if required by code. Pump Output The Aqua Trol's filter pump output is rated at 120 VAC, 15 A max. Check the electrical rating marked on the pump motor. Connecting a pump with a higher amperage rating may result in permanent damage to the Aqua Trol. The 120 VAC standard or twist lock pump receptacle is located outside, on the bottom of the enclosure. Electrolytic Cell and Flow Switch The cell and flow switch plug into connectors on the Aqua Trol electronics unit. Note that return jet units (-RJ option) will NOT have a flow switch. See diagram below. Phone jack to flow switch Cutout for cell cable to GF1CI2NI0PreVUcATeCpPtlOaincWelecE/obRrrdeaker1O20UtoTVPApUoCoTrlePpcuOemWptpaEcRle Bonding lug to pool bonding system 12