Hayward Aqua Solar® Aqua Solar - Page 7

AQ-SOL-LV-TC with filter pump & booster pump relays Aqua Solar 240 (AQ-SOL-LV-TC) VAC 240 VAC Booster Pump Pool Sweep Filter Pump 240 VAC Ground Solar Booster Pump Filter Pump NOTES: 1) Do not use Aqua Solar terminal block as a junction for pump wiring. 2) Most codes require that each pump be on a separate circuit. AQ-SOL-LV-TC with filter pump & pool sweep relays 120/240 VAC Pool Sweep Timer 240 VAC Aqua Solar (AQ-SOL-LV-TC) Booster Pump Pool Sweep Filter Pump 240 VAC Ground Sweep Pump Filter Pump NOTES: 1) Do not use Aqua Solar terminal block as a junction for pump wiring. 2) Most codes require that each pump be on a separate circuit. 3) Aqua Solar will ensure sweep pump runs only when filter pump is running. 4) Sweep pump will turn off for approximately 5 minutes when solar turns on. 7 INSTALLATION Mounting The Aqua Solar is designed for outdoor use. Mount the enclosure vertically with the knockouts facing downward. For safety, the Aqua Solar must be a minimum of 5 feet (horizontally) from the pool or spa. Power input Turn off power at circuit breaker before wiring. Follow NEC and all local electrical codes. Wire to either 120VAC or 240VAC per the diagram below. If the Aqua Solar is being powered from the same circuit as one of the pumps, wire to the relay first and then jumper over the Aqua Solar terminal block. Do NOT use the Aqua Solar terminal block as a junction for pump power, the terminal block is not rated for high amps. Be sure to connect the earth ground to the green terminal. Fuse (2A, Slo-Blo) Relay Control Outputs Booster Pump Pool Sweep (heater interlock for -SP model) Filter Pump Rev Fwd } Valve Output Solar Pool Aux Input Power 120VAC 240 VAC Ground Cooling Recirculate/ Freeze Protection Celsius/ Fahrenheit Solar Override Temperature Sensor Inputs Output wiring to solar diverter valve Most installations use a solar valve, which diverts water through the collector panels when solar heat is available. For Hayward, Jandy, and Compool valve actuators (with wire end connectors), two 3-pin connectors are supplied. Plug the actuator into one of the Aqua Solar's two 3-pin connectors (see diagram above for location of connectors). If the valve operates opposite to the way it is supposed to, disconnect and plug into the other connector. 4