Hayward ColorLogic 2.5 Model: Series SP0521 - Page 1
Hayward ColorLogic 2.5 Manual
View all Hayward ColorLogic 2.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HAYWARD Underwater ColorLogie LED Lighting Fixtures FOR SWIMMING POOLS OWNER'S GUIDE INSTALLATION AND OPERATING INSTRUCTIONS UL Listed File No. E234517 0 GENERAL INFORMATION MODEL # VOLTAGE WATTAGE WIRE SIZE The Hayward ColorLogic LED (light-emitting diode) underwater lighting fixture you have purchased is designed to mount into Hayward DuraNiche Series models SP600 and SP607 SP-0521LED30 manufactured 1993 and later. Hayward light fixtures may fit into other niches, but the installation SP-0521LED50 120VAC 50W #14 AWG will not carry a U.L. approval. SP-0521LED100 Hayward SP520 Series ColorLogic LED lights are U.L. listed under file number E234517 and, to be approved, must be used with Hayward models SP600 or SP607 fixture housings (niches). Installation of light and niche must be in accordance with Article 680 of the National Electric Code (N.E.C.) and any applicable local codes. If non-metallic conduit is used, a #8 AWG grounding conductor must be run through the conduit and connected to the grounding connector on the inside of the niche. This connection must be encapsulated using a listed potting compound in accordance with N.E.C. Article 680-20, such as 3M Inc. Scotch Cast Wet Niche Potting Compound No. 2135 (U.L. File E130394) or equivalent. The integral external connection on the niche is for the #8 AWG bonding conductor also required by the N.E.C. Please refer to your niche installation instructions for details. Except when the fixture is installed in an area of the swimming pool that is not used for swimming and the lens is adequately guarded to keep any person from contacting it, the fixture must be installed in or on a wall of the pool, with the top of the lens not less than 4 inches (10.2 cm) below the normal water level of the pool. Important Note When Installing SP-600 Niche (for ConcretelGunite Pools): A cover and two screws have been provided to protect the niche and mounting screw holes. Leave these in place during construction to prevent intrusion of concrete which may foul the niche or threads. REMOVE and discard both the screws and the protective cover when ready to install the light fixture. IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: Failure to follow instructions may result in injury. 1. Warning - Risk of Electric Shock. Do not open. Pool light has no user serviceable parts inside. 2. Warning - To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. 3. Caution - This swimming pool light is U.L. Listed for permanently installed pools only. It is not listed for storable pools. Permanently installed pools are those constructed in or partially in the ground and all others capable of holding water in a depth greater than 42 in (1.07 m). Storable pools are those constructed on or above the ground and capable of holding water to a maximum depth of 42 in (1.07 m). 4. This Light Fixture must be installed by qualified personnel in compliance with the National Electric Code (N.E.C.) and any applicable local codes. 5. Disconnect electrical power before installing or servicing this equipment. 6. Improper installation may result in death or serious injury to bathers or service personnel or others by way of electric shock. Read and follow all instructions. SAVE THESE INSTRUCTIONS CAUTION: Local electrical codes and/or regulations must be followed when installing this light fixture.