Hayward H400FDN Universal H Series Troubleshooting Guide - Page 33
Verify ignitor resistance, Ignitor and blower wiring, Measure blower resistance
View all Hayward H400FDN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4. Open FC4 Fuse Ignitor and blower wiring Step 4A Verify ignitor resistance Step 4B Inspect the Ignitor & Blower wiring. Verify insulation is not damaged. IF wires are damaged, replace the damaged part (pg. 20). IF OK, go to 4B. Disconnect ignitor from ICB & measure resistance of ignitor. Verify 8-25 ohms between 20°-140°F. IF correct, go to 4C. IF NOT, replace ignitor (pg. 20). Measure blower resistance Step 4C Before Sept. 2010 With power off, disconnect blower plug from ICB. Models manufactured before Sept. 2010: measure across pins 1-2 (black & red), then 3-4 (white & blue) for 8-9 ohms. Models after Sept. 2010: measure for 4-5 ohms across the two terminal with wires. IF out-of-range, replace 33 blower (pg. 20). IF correct, contact technical support (908)355-7995.