Hayward OnCommand Model: ALL MODELS Installation - Page 22
Solar, Solar Extend, Solar Priority, Allow Low Speed - pool control system
View all Hayward OnCommand manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Solar Config. + to view/change Solar Disabled if "Solar" is enabled Solar-Extend Disabled if "Solar" is enabled Solar Priority Disabled if "Solar" is enabled and "1-speed Filter" is not selected Allow Low Speed Disabled Push to access solar options Move to previous/next configuration menu Toggle between Enabled and Disabled (default) Solar Move to next menu item or previous/next configuration menu Toggle between Enabled and Disabled (default) Solar Extend Move to next menu item Toggle between Enabled and Disabled (default) Solar Priority Move to next menu item Toggle between Enabled and Disabled (default) Move to next menu item or previous/next configuration menu Solar If the solar control logic is "Enabled", several additional steps must be taken to ensure proper operation of the solar system. If the solar is operated by a valve, then the Valve3 output must be setup for solar logic. If the solar is operated by a pump, then one of the AUX relays must be set up for solar logic. Also, the "solar" temperature sensor must be installed. This sensor is typically mounted near the collector array and is used to sense whether sufficient solar heat is available. If solar is "Enabled", the valve or solar pump relay will turn on when the water temperature is less than the desired temperature setting AND the solar sensor is hotter than the water. The desired temperature is in the "Settings Menu". If applicable, the homeowner will be prompted to enter separate pool and spa desired temperature settings. Depending on the position of the pool/spa suction valve, the proper temperature setting will be used. Solar Extend If "Enabled", the filter extend logic keeps the filter pump running beyond the normal turn-off time if solar heat is still available. When solar heat is no longer available, both the solar valve/pump and filter pump will turn off simultaneously. Solar extend will NOT cause the filter pump to turn on, it will only delay the turn off time when solar is operating. Solar Priority If both "Solar Control" and "Heater Control" are enabled, the Solar Priority feature will keep the conventional heater off whenever solar heat is available. This provides the most cost effective way of heating the pool. When solar heat is not available, the conventional heater will operate normally. Allow Low Speed This menu only appears if the pool filter is configured for 2-speed or variable speed operation. During default operation, high speed mode is used whenever the solar heater is on. If Allow Low Speed is enabled, low speed pump operation will be allowed during solar heating except for the first 3 minutes after solar heat turns on. 19