Hayward Pro Logic® Model: PL-P-4 Installation - Page 20

Temperature Sensors, Remote Display/Keypad

Get Hayward Pro Logic® PDF manuals and user guides View all Hayward Pro Logic® manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Temperature Sensors The Pro Logic utilizes 10K ohm thermistor type sensors. Three sensors (water temperature, air temperature and solar temperature) are included. If the Pro Logic is being used to control a solar heating system, the solar sensor is required. The sensors are provided with a 15 ft. cable. See page 5 and the diagram below for installation information. POOL/SPA SENSOR AIR SENSOR SOLAR/SPA SENSOR Remote Display/Keypad The Pro Logic main unit can connect to a maximum of 3 remote wired display/keypads (ordered separately). Use four conductor cable (typically phone cable) to connect the wired remote display/keypad with the Pro Logic Control Center as shown below. The maximum wiring distance is 500ft. (160m). Note that the terminals on both the Pro Logic main unit and the wired remote display/keypad are numbered: Connect 1 to 1, 2 to 2, etc. Refer to diagram below. 3.75 " Remote Display unit 4 321 500 ft max 4.50 " Alternative Concealed Wiring If multiple remote display/keypads are installed: Never connect more than 2 wires to any terminal block. Two remotes can be wired back to the Pro Logic main unit or the second display/keypad (and third, if applicable) can be "daisy chained" with one display/keypad wired to the next. The maximum wire run from the Pro Logic main unit to the furthest remote display/keypad is 500 ft (160m). 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Temperature Sensors
The Pro Logic utilizes 10K ohm thermistor type sensors.
Three sensors (water temperature, air temperature and solar
temperature) are included.
If the Pro Logic is being used to control a solar heating system, the solar sensor is required.
The sensors are provided with a 15 ft. cable.
See page 5 and the diagram below for installation information.
AIR
SENSOR
SOLAR/SPA
SENSOR
POOL/SPA
SENSOR
Remote Display/Keypad
The Pro Logic main unit can connect to a maximum of 3 remote wired display/keypads (ordered separately).
Use four conductor cable (typically phone cable) to connect the wired remote display/keypad with the Pro Logic
Control Center as shown below.
The maximum wiring distance is 500ft. (160m).
Note that the terminals on both the
Pro Logic main unit and the wired remote display/keypad are numbered:
Connect 1 to 1, 2 to 2, etc.
Refer to diagram
below.
Remote Display unit
Alternative
Concealed Wiring
1
2
3
4
500 ft max
3.75 ”
4.50 ”
If multiple remote display/keypads are installed:
Never connect more than 2 wires to any terminal block.
Two
remotes can be wired back to the Pro Logic main unit or the second display/keypad (and third, if applicable) can be
“daisy chained” with one display/keypad wired to the next.
The maximum wire run from the Pro Logic main unit to the
furthest remote display/keypad is 500 ft (160m).
17