Hayward Universal ColorLogic® Universal ColorLogic and CrystaLogic Instal - Page 12

Operation Universal ColorLogic/CrystaLogic Light modes The Hayward Universal ColorLogic/CrystaLogic light is designed to operate in one of four modes; Universal ColorLogic (default), ColorLogic 4.0, ColorLogic 2.5 & earlier and Pentair SAM. Universal ColorLogic mode (default): The light is shipped in this mode. Use this mode for new installations and for installations with other Universal ColorLogic/CrystaLogic lights. ColorLogic 4.0 mode: Use this mode when installing your new light in systems with ColorLogic 4.0 lights. The Universal ColorLogic/CrystaLogic light will be "seen" as another ColorLogic 4.0 light and will operate in the same manner as the others. ColorLogic 2.5 & earlier mode: Use this mode when installing your new light in systems with ColorLogic 2.5 & below lights. The Universal ColorLogic/ CrystaLogic light will be "seen" as another ColorLogic 2.5 & earlier light and will operate in the same manner as the others. Pentair SAM: Use this mode when installing your new light in systems with Pentair SAm® or SAL® lights. The Universal ColorLogic/CrystaLogic light will be "seen" as another Pentair SAm®/SAL® light and will operate in the same manner as the others. How to change modes: 1. Turn on lights and then turn off for between 11-15 seconds. 2. Turn on lights and then turn off for between 11-15 seconds. 3. Turn on lights and then turn off for between 11-15 seconds. 4. The light should blink one of 4 colors indicating which mode it is currently in. Refer to the table below to determine which mode the Universal Color- Logic/CrystaLogic is in. Note that new lights are shipped from the factory in Universal ColorLogic mode (blinking red). 5. To change modes, turn light off and back on. The light will then advance to the next mode. Continue this method until you arrive at the desired mode. 6. When the light is in the desired mode, remove power from the lights for at least one minute. 7. The light will restart in the new mode the next time it is turned on. Operating the Universal ColorLogic/CrystaLogic Light The Universal ColorLogic/CrystaLogic light is controlled through power-cycling: a method of changing light programs which requires no special controller or interface. To activate the light, simply turn on the switch. To deactivate the light, turn off the switch. To advance to the next light program (fixed color or color show), turn the switch off, then back on within 10 seconds. When the light has been off for over 60 seconds, and is first turned on, it will come on to white for 15 seconds for quick clear view of your pool, then go to the last fixed color or color show it was running. Light Synchronization If your pool or spa has multiple Hayward Universal ColorLogic/CrystaLogic LED lights, they may be operated independently, or they can be easily synchronized so they will all display the same colors and shows at the same time. For light synchronization, all lights must be wired to the same switch. Once installed, all lights should be automatically synchronized, however, if they get out of sync, they can be re-synchronized easily. To re-synchronize your lights, 12 USUESEONOLNYLYHAHYAWYWARADRDGEGNEUNIUNIENERERPELPALCAECMEMENETNTPAPRATRSTS