HealthRider 15.5 S Treadmill Canadian English Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner. Assembly requires the included hex keys and your own Phillips screwdriver let , adjustable wrench , and wire cutters . , rubber mal- To identify assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of the manual. The number following the parentheses is the quantity used in assembly. To avoid damaging plastic parts, do not use power tools for assembly. Handrail Bolt (20)-4 3/4" Screw (2)-6 Wheel Spacer (44)-4 1/4" Star Washer (21)-2 Upright Bolt (40)-4 Wheel Bolt (95)-2 Silver Ground Screw (27)-2 Frame Washer (33)-2 Handrail Star Washer (19)-4 Frame Bolt (32)-2 Console Bolt (22)-2 1. Orient the Base (48) as shown. 1 Identify the Right Upright (36), which has a square hole near the lower end. Orient the Right Upright (36) as shown, and attach it to the Base (48) with two Upright Bolts (40) and two Upright Star Washers (39); do not tighten the Upright Bolts yet. Frame Bolt (32)-2 6 Nut (47)-4 Upright Star Washer (39)-4 36 48 Square Hole 39 40 39 40