HealthRider 15.5 S Treadmill Canadian English Manual - Page 9

7. Route the Upright Wire (28) through one of the Handrails (18) as shown, and remove the wire tie from the Upright Wire. Attach the Handrail (18) to the Right Upright (36) with two Handrail Bolts (20) and two Handrail Star Washers (19). Be careful not to pinch the Upright Wire (28). Attach the other Handrail (18) to the Left Upright (31) with two Handrail Bolts (20) and two Handrail Star Washers (19). 7 20 19 18 31 20 28 Wire Tie 19 18 36 8. While another person holds the Console Base (26) near the right Handrail (18), attach the 8 ground wire on the Console Base to the right Handrail with a Silver Ground Screw (27). Connect the wire harness on the Console Base (26) to the Upright Wire (28) as shown in the inset drawing. If the connectors are oriented correctly, they will slide together easily and snap into place. If it does not, turn the end of the Wire Harness and then insert it. IF THE CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Wire Harness 28 26 27 Ground Wire 18 28 9. Insert the wires into the Console Base (26) as 9 you set the Console Base on the Handrails (18). Be careful not to pinch the wires. Next, thread two Console Bolts (22) with 1/4" Star Washers (21) into the Handrails and the Console Base; 18 do not tighten the Console Bolts yet. Attach the Console Base (26) to the Handrails (18) with four 3/4" Screws (2). Then, tighten the two Console Bolts (22). 2 26 Front View 18 21 2 22 21 22 9