HealthRider Aerobic Rider 2 English Manual - Page 7
Make sure that all parts are properly tightened.
View all HealthRider Aerobic Rider 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
9. Depress the two buttons on the sides of the 9 Handlebar Assembly (6) with your thumb and fore- finger. Insert the Handlebar Assembly (6) into the Handlebar Swing Arm (5). Make sure that the but- tons protrude through one of the two sets of holes in the Handlebar Swing Arm. The upper holes offer lower workout resistance; the lower holes offer higher resistance. 6 Buttons Holes 5 10. Slide the Monitor (35) fully onto the Main Frame (1) as shown in inset drawing A. Press down on the Monitor as shown in inset drawing B until it snaps into place. 10 35 1 A 35 1 B 35 1 11. Remove the battery cover from the Monitor (35). 11 Insert two new AA batteries into the Monitor. Identify the negative (-) and positive (+) ends of the batter- ies. The springs in the battery compartment should touch the negative ends of the batteries. (+) (-) 35 Battery Cover (-) (+) AA Batteries 12. Make sure that all parts are properly tightened. To protect the floor or carpet from damage, place a mat under the AEROBIC RIDER 2. 7