HealthRider C865e Elliptical English Manual - Page 22

MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. For smooth operation of the elliptical exerciser, inspect Ramp and clean the ramp regularly using a soft cloth and mild detergent. Other parts of the elliptical exerciser can also be cleaned in this way. Keep liquids off the console. Never use abrasives or solvents. HOW TO MOVE THE ELLIPTICAL EXERCISER Stand in front of the elliptical exerciser, hold the upper body arms firmly, and place one foot against the ramp in the location shown below. Pull the upper body arms until the elliptical exerciser can be moved on the front wheels, and carefully move the elliptical exerciser to the desired location. Then, place one foot against the ramp, and lower the elliptical exerciser. Due to the size and weight of the elliptical exerciser, use extreme caution while moving and lowering it. Upper Body Arm PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 6 on page 13. Place your foot here HOW TO CALIBRATE THE INCLINE SYSTEM If the elliptical exerciser's incline system is not working properly, activate the calibration process by following the steps below. Wheel 1. Hold down the + button and the Program button at the same time for about five seconds. Note: Numbers may appear in the left and right displays. Disregard these numbers. HOW TO LEVEL THE ELLIPTICAL EXERCISER 2. Press the Program button again. Note: A combination of letters and numbers may appear in the displays. 3. Press the 30° Ramp button. The ramp will move all of the way up and then all of the way down. 4. Press the Program button three times. The console will then be in the normal operating mode and the elliptical exerciser will be ready for use. If the elliptical exerciser rocks during use, turn one or both of the leveling feet under the rear stabilizer until the rocking motion is eliminated. Leveling Foot 22