HealthRider H150o Treadmill English Manual - Page 8

7. Insert the excess Wire Harness (17) down into the Right Upright (10) as you set the right Handrail (85) on the Right 7 87 Upright. Hand tighten two 4" Bolts (89) with two Star Washers (4) through the Right Upright into the right 17 Handrail. Be careful not to pinch the Wire Harness. Do not tighten the Bolts yet. Attach the left Handrail to the Left Upright (not shown) in the same way. Note: There is not a wire harness in the Left Upright. 4 89 85 10 8. Hold the Connector Cover (110) on the Console Base (87) in the position shown. Attach the Connector Cover 8 to the Console Base with two 3/4" Screws (68). 110 68 87 9. Remove the Lock Knob (105) from the Lock Pin (11). Make sure that the Lock Pin Collar (14) and the Spring (56) are on the Lock Pin as shown. Insert the Lock Pin into the Storage Latch (77) and tighten the Lock Knob onto the Lock Pin. 9 85 105 77 9 56 14 11 10.Lower the Uprights (9, 10) until the Handrails (not 10 shown) are touching the floor. Make sure that the tread- mill Frame (12) is centered between the Uprights. See step 3. Firmly tighten the four 3" Bolts (47). See step 7. Firmly tighten the four 4" Bolts (89). Raise the Uprights back to the vertical position. Make sure that the two Cup Holders (39) are pressed into the round holes on top of the Console Base (87). 10 Top View 87 39 9 12 11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet from damage, place a mat under the treadmill. 8