HealthRider H150t Treadmill User Manual - Page 9
See the inset drawing., Be careful not to pinch the wires., do not, fully tighten the Screws yet.,
View all HealthRider H150t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4. Identify the Left Upright (84). Have a second person hold the Left Upright near the Base (29). 4 See the inset drawing. Tie the wire tie in the Left Upright (84) securely around the end of the Upright Wire (91). Then, pull the other end of the wire tie until the Upright Wire is routed through the Left Upright. 84 91 84 Wire Tie Wire Tie 91 91 29 5. Hold the Left Upright (84) against the Base (29). Be careful not to pinch the wires. If necessary, position the base ground wire (A) in the hole in the side of the Left Upright. Insert two 3/8" x 2 3/4" Screws (22) with two 3/8" Star Washers (10) and two 3/8" x 1 1/4" Screws (3) with two 3/8" Star Washers (10) into the Left Upright. Partially tighten the 3/8" x 2 3/4" Screws (22) and the 3/8" x 1 1/4" Screws (3) until the heads of the Screws touch the Left Upright (84); do not fully tighten the Screws yet. Note: It may be helpful to use the short hex key (B) on the Screw shown. Attach the Right Upright (not shown) in the same way. Note: There are no wires on the right side. 5 84 22 B 10 10 A 3 10 29 9