HealthRider H20t Treadmill English Manual - Page 8

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 7. • Assembly requires the following tools: the included hex key needlenose pliers one Phillips screwdriver To avoid damaging parts, do not use power tools. 1. Go to www.iconservice.ca/CustomerService/ registration and register your product. 1 • activates your warranty • saves you time if you ever need to contact Customer Service • allows us to notify you of upgrades and offers Note: If you do not have Internet access, call Customer Service (see the front cover of this manual) and register your product. 2. Make sure that the power cord is unplugged. 2 With the help of a second person, carefully tip 73 the treadmill onto its left side. Unfold the Frame (50) away from the Uprights (73). Do not lean on the Uprights. Next, orient the Base (42) as shown. Attach the Base to the Uprights (73) with four M10 x 65mm Screws (1); start all four Screws, and then 50 tighten them. Then, carefully tip the treadmill down so that the Base (42) is flat on the floor. 8 42 1 1