HealthRider H50 Crosswalk Sl Treadmill English Manual - Page 7
Assembly - parts
View all HealthRider H50 Crosswalk Sl Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • T o hire a service technician to assemble this product in your home, call 1-800-445-2480. • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex keys one Phillips screwdriver scissors To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Remove and discard the two screws (A) and the shipping bracket (B) from the right side of the Base (74). Remove and discard the screws and shipping bracket (not shown) from the left side of B the Base. A 74 2. Locate the Upright Wire (63) bundled around the Base (74). Cut the plastic tie securing the 2 Upright Wire. Pull the end of the Upright Wire out of the indicated hole. See the inset drawing. Cut the plastic tie near the Upright Wire (63). Be careful not to damage the Upright Wire. Press a Base Cap (70) into each side of the Base (74). 7 74 63 Cut Hole 70 Tie Cut 63