HealthRider R60 Treadmill Canadian English Manual - Page 8
If you purchase the optional chest pulse sensor see follow the steps below to install
View all HealthRider R60 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screws (40) from the Console Back (117). 1 Remove the Console Back. 2. Connect the short jumper wire (A) to the wire on the receiver (B). Connect the other end of the short jumper wire to 2 the PULSE jack on the back of the Console (80). Turn the receiver (B) so the cylinder is in the position shown, and hold the receiver against the back of the Console (80). Attach the receiver with the two small screws (C) included with the receiver. Make sure that no wires are pinched. See step 1. Reattach the Console Back (117) with the 3/4" Screws (40). Discard the other wires included with the receiver. 117 40 40 80 A Cylinder B C 8