HP 22-b100 Hard Drive Replacement Instructions 1
HP 22-b100 Manual
 |
View all HP 22-b100 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 22-b100 manual content summary:
- HP 22-b100 | Hard Drive Replacement Instructions 1 - Page 1
Hard Drive Replacement Instructions 852272-001 Before you begin Observe the following requirements before removing and replacing the hard drive. WARNING: Never open the cover while the power cord - HP 22-b100 | Hard Drive Replacement Instructions 1 - Page 2
5. Starting with the gap at the top of the cover, pry the top (1), left edge (2), and right edge (3) of the cover away from the display assembly in the order shown. 6. To avoid damaging the cable that connects the system board to the rear cover, carefully lift the bottom edge of the cover, and then - HP 22-b100 | Hard Drive Replacement Instructions 1 - Page 3
Replacing the hard drive 1. Orient the hard drive to match the orientation of the old hard drive - that is, which side is up and the position of the connector. Slide the drive into the hard drive cage (1), and then replace the four Phillips screws (2). 2. Insert the drive cage into the computer - HP 22-b100 | Hard Drive Replacement Instructions 1 - Page 4
the instructions included with your system recovery discs, or for U.S. product support, go to http://www.hp.com/go/contactHP. For worldwide product support, go for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should
-
1 -
2 -
3 -
4
 |
 |
852272-001
1
Hard Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the hard drive.
WARNING
: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static electricity
by touching the metal cage of the computer before touching
any internal parts or electronic components.
CAUTION
: A hard drive is extremely sensitive to shock
and impact. Do not bang or drop it.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
NOTE
: Computer appearance and features may vary by
model.
Removing the hard drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
Using caution, lay the computer down on a flat surface
covered with a soft cloth.
3.
To remove the stand, loosen the two captive screws in the
bottom of the stand, and then remove the stand from the
computer.
4.
To remove the rear cover, remove the Phillips screw
located at the bottom of the cover.
852272-001