HP 22-b100 Hard Drive Replacement Instructions 1 - Page 2

5. Starting with the gap at the top of the cover, pry the top (1), left edge (2), and right edge (3) of the cover away from the display assembly in the order shown. 6. To avoid damaging the cable that connects the system board to the rear cover, carefully lift the bottom edge of the cover, and then rotate the cover until it rests upside down next to the display assembly. 7. Locate the hard drive: Hard drive (1) Memory modules (2) Optical drive (3) 8. Disconnect the cable from the hard drive (1). Remove the Phillips screw that secures the drive cage (2), and then remove the drive cage from the computer (3). 9. Remove the four Phillips screws from the sides of the hard drive cage (1), and then slide the hard drive out of the drive cage (2). NOTE: Be sure to note the orientation of the hard drive (which side is up and the position of the cable connector) before removing the hard drive. 10. Touch the replacement hard drive bag to the metal of the computer, and then remove the replacement hard drive from the bag. 852272-001 2