HP 330834-B21 HP StorageWorks Ultrium Tape Drive External Model Getting Starte - Page 42

LED Sequence Cause Action required Ready is FLASHING fast. None. The drive is Do not reset or power cycle the drive. downloading firmware. Ready is OFF, others are ON. Firmware is being reprogrammed. None. Do not reset or power cycle the drive. Clean is FLASHING. The drive requires cleaning. Load the Ultrium cleaning cartridge. See page 24 for supported cartridges and instructions. If the Clean LED is still flashing when you load a new or known data cartridge after cleaning, call for service. Ready is FLASHING and None. The cleaning cartridge will eject on Clean is ON. completion. Cleaning is in progress. The cleaning cycle can take up to 5 minutes to complete. Tape Error is FLASHING. Unload the tape cartridge. Make sure that you are The drive believes the using the correct format cartridge; an Ultrium data current tape or the tape cartridge or Ultrium Universal cleaning cartridge. just ejected is faulty. (See page 24.) Reload the cartridge. If the Tape Error LED still flashes or starts flashing during the next backup, load a new or known, good cartridge. If the Tape Error LED is now off, discard the 'suspect' tape cartridge. If it is still on, call for service. The tape is ejected Write-protect the cartridge by sliding the red switch immediately and Tape on the tape cartridge. The tape can be loaded and Error is FLASHING, or the data read. Once the data is recovered, the or Drive Error FLASHES on cartridge must be discarded. unloading tape. The tape cartridge memory (CM) may be faulty. Drive Error FLASHING. The drive mechanism has detected an error. Load a new cartridge. If the error persists, power cycle or reset the drive. If the Drive Error LED remains on, call for service. 40