HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Confi - Page 93

Step Command 3. Enable the interface to add its MTU into DD packets. ospf mtu-enable Remarks Optional. Not enabled by default. Configuring the maximum number of external LSAs in LSDB Step 1. Enter system view. 2. Enter OSPF view. Command system-view ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * 3. Specify the maximum number of external LSAs in the LSDB. lsdb-overflow-limit number Remarks N/A N/A Optional. Not specified by default. Enabling compatibility with RFC 1583 RFC 1583 specifies a different method than RFC 2328 for selecting an external route from multiple LSAs. If RFC 1583 is made compatible with RFC 2328, the routes in the backbone area are preferred; if not, the routes in the non-backbone area are preferred to reduce the burden of the backbone area. To avoid routing loops, HP recommends configuring all the routers to be either compatible or incompatible with RFC 1583. To make them compatible: Step 1. Enter system view. 2. Enter OSPF view. 3. Enable compatibility with RFC 1583. Command system-view ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * rfc1583 compatible Remarks N/A N/A Optional. Enabled by default. Logging neighbor state changes Step 1. Enter system view. 2. Enter OSPF view. 3. Enable the logging of neighbor state changes. Command system-view ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * log-peer-change Remarks N/A N/A Optional. Enabled by default. 83