HP 6910p HP Compaq 6910p Notebook PC - Maintenance and Service Guide - Page 93
MultiBay II eject assembly, Display assembly see
UPC - 883585172306
View all HP 6910p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
MultiBay II eject assembly Description MultiBay II eject assembly Spare part number 446434-001 Before removing the MultiBay II eject assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC Adapter from the computer. 4. Remove the battery (see Battery on page 40). 5. Remove the following components: a. Hard drive (see Hard drive on page 44) b. Bluetooth module (see Bluetooth module on page 46) c. MultiBay II device (see MultiBay II device on page 54) d. Keyboard (see Keyboard on page 55) e. Switch cover (see Switch cover on page 62) f. Fan assembly (see Fan assembly on page 64) g. Heat sink (see Heat sink on page 65) h. Display assembly (see Display assembly on page 69) i. Top cover (see Top cover on page 74) j. Smart card reader board (see Smart card reader board on page 77) k. Microphone (see Smart card reader board on page 77) l. Speaker assembly (see Speaker assembly on page 79) m. System board (see System board on page 80) Remove the MultiBay II eject assembly: 1. Remove the Phillips PM2.0×6.0 screw (1) that secures the MultiBay II eject assembly to the base enclosure. Component replacement procedures 85