HP 8/24 Brocade Fabric OS Administrator's Guide v6.3.0 (53-1001336-01, July 20 - Page 352
Authentication of EX_Port, VE_Port, and VEX_Port connections, Table 53
View all HP 8/24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 352 highlights
14 E_Port authentication between Fabric OS and M-EOS switches TABLE 59 Switch authentication policy when connected to an M-EOS dumb switch M-EOS Disabled Fabric OS Passive Active On Off Yes Connected without any authentication (Fabric builds normally). No E_Port does not connect (Authentication Rejected). When the Fabric OS switch generates the reject, it disables the Fabric OS port. When the M-EOS switch generates the reject, it goes to an invalid attachment state. No E_Port does not connect (Authentication Rejected). When the Fabric OS switch generates the reject, it disables the Fabric OS port. When the M-EOS switch generates the reject, it goes to an invalid attachment state. Yes Connected without any authentication (Fabric builds normally). Because the M-EOS switch does not know about authentication, there is never an authenticated connection made. However, the E_Port is established when the Fabric OS switch is configured in Passive or Off states. The cases where the connection fails are when the Fabric OS switch is configured as On or Passive. This is because these states require the authentication of the E_Ports to respond to authentication requests. See Table 53 on page 305 for the Fabric OS mode descriptions. The Passive and Off cases never exchange authentication frames, and therefore come up as normal E_Ports. Authentication of EX_Port, VE_Port, and VEX_Port connections VE_Ports run authentication the same as E_Ports; for information on authenticating E_Ports, see "E_Port authentication between Fabric OS and M-EOS switches" on page 304. EX_Ports and VEX_Ports both run authentication in Passive mode. This means these ports will not initiate authentication, but they will respond to authentication requests initiated by the connecting switch. Changing the switch authentication policy mode does not affect the authentication function of EX_Ports; they remain in Passive mode. If you connect an M-EOS switch in On mode to an EX_Port set to McDATA Open Fabric mode or McDATA Fabric mode, authentication should work the same as connecting an M-EOS switch to a Fabric OS switch in Passive mode. The authenticated connection is successful if the M-EOS switch has the correct secret for the Fabric OS switch and the Fabric OS switch has the correct secret for the M-EOS switch. NOTE The EX_Port's secret is configured on the Fabric OS switch the same way it is configured for an E_Port. However, the front domain WWN should be used to install the shared secret on the E_Port side. M-EOS switches do not support VE_Port or VEX_Port connections; any configurations with these port types are Fabric OS-only configurations. However, both VE and VEX_Ports support running in McDATA interop mode. 310 Fabric OS Administrator's Guide 53-1001336-01