HP 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June - Page 664
switchCfgTrunk
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 664 highlights
2 switchCfgTrunk switchCfgTrunk Enables or disables trunking on all the ports of a switch. Synopsis switchcfgtrunk mode Description Use this command to enable or disable trunking on all the ports of a switch. Use portCfgTrunkPort to enable or disable trunking on a single port. When the command is executed to update the trunking configuration, the ports to which the configuration applies are disabled and subsequently re-enabled with the new trunking configuration. Traffic through these ports may be temporarily disrupted. Disabling trunking fails if a Trunk Area (TA) is enabled on the port. Use the portTrunkArea command to disable the TA on all ports before disabling trunking. Notes Enabling trunking requires an ISL Trunking license. You may disable trunking without a license. The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands The following operand is required: mode Specify 1 to enable trunking on all ports. Specify 0 to disable trunking on all ports. Examples To disable trunking on all ports of a switch: switch:admin> switchcfgtrunk 0 Committing configuration...done. See Also portCfgShow, portCfgTrunkPort, portShow, portTrunkArea, switchShow 638 Fabric OS Command Reference 53-1000599-02