HP 9050 HP LaserJet MFP - Analog Fax Accessory Guide - Page 115
Send-fax messages, Table 4-1 - ram
UPC - 829160315386
View all HP 9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Send-fax messages Table 4-1 Send-fax messages Message Error No. Cancelled 0 Success n/a Fail Busy 0 No Answer 0 Compression Error Any No Dial 0 Modem Fail Any Communication Error Communication Error 17 or 36 Any besides 17 or 36 Space Fail Page Fail Memory Error Job Fail Power Failure No Fax Detected 0 0 0 Any 0 17 or 36 Description Action(s) Fax was cancelled by user at None. control panel of MFP. Fax sent successfully. None. The receiving fax machine is busy. The fax will be retired automatically (if configured), otherwise try resending fax later. The receiving fax machine is not answering the call. The receiving fax machine may be disconnected or turned off; contact the receiver to check the machine. Try resending. Fax may be corrupted or not Try resending fax. sent. No dial tone is detected when Verify the phone line is active; sending the fax. set the sending fax to "not" to detect a dial tone. Unexpected or bad response Try resending fax; if the error from the internal fax modem persists, contact service. to MFP. Lost telephone connection Try resending the fax. between sender and receiver. General communications issue where the fax transmission was interrupted or did not proceed as expected. Try resending fax; if the error persists, contact service. Unable to read or write the fax image file to disk; could be corrupt MFP disk or no space available on the MFP's disk. Try resending fax; if the error persists, contact service. Incompatible page width, or Try resending fax; if the error page had too many bad lines. persists, contact service. Out of RAM memory on MFP. If error persists, may need to add RAM to MFP. Fax failure; the fax job did not Try resending fax; if the error complete. persists, contact service. A power failure occurred Try resending the fax. during the fax transmission on the sending fax MFP. No fax machine was detected at receiving end. Verify fax number and have receiver verify fax machine is on and connected; then try resending fax. ENWW Fax error messages 107