HP AH558A HP StorageWorks 1/8 G2 Tape Autoloader Addendum (AK377-96004, June 2 - Page 6
Con, guration: Network Management
UPC - 808736893589
View all HP AH558A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Configuration: Network Management Use the Configuration: Network Management page to enable and configure SNMP (Simple Network Management Protocol), which allows applications such as HP Systems Insight Manager (http://www.hp.com/products/SystemInsightManager) to manage the device. The device supports both SNMP configuration and SNMP traps. SNMP can only be configured with the RMI; it cannot be configured with the OCP. Figure 3 Configuration: Network Management page You may change the: • SNMP Enabled - When checked, the device can be managed by computers listed in the SNMP Target IP Addresses field. • SNMP Target IP Addresses - the IP addresses for up to three computers for IPv4 and three computers for IPv6 running SNMP management software. IP addresses will not be cleared if SNMP is disabled, but those targets will no longer be able to manage the Autoloader and will not receive traps from the Autoloader. You can select the SNMP version for each target address. • Community Name - a string used to match the SNMP management station and device. It must be set to the same name on both the management station and the Autoloader. The default community name is public. • SNMP Trap Notification Filter - the types of events for which the device should send SNMP traps. For instructions on configuring HP Systems Insight Manager for the Tape Autoloader, see the User and service guide on the documentation CD. 6