HP Bc1500 HP BladeSystem PC Blade Switch Installation Guide - Page 25

console&gt, configconfig, consoleconfig, To con SNMP station IP address and community strings

Get HP Bc1500 - BladeSystem - Blade PC PDF manuals and user guides View all HP Bc1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

To configure SNMP station IP address and community string(s), perform the following: 1. At the console prompt, type Enable. The prompt is displayed as #. 2. Type configure and press Enter. 3. In configuration mode, type the SNMP configuration command with the parameters including community name (private), community access right (read and write) and IP address, as shown in the following example: console> enable console# configure config(config)# snmp-server community private rw 192.168.1.2 config(config)# exit console(config)# show snmp Community-String private Community-Access readWrite View Name default IP address 192.168.1.2 Community-String Group name IP address Type Traps are enabled. Authentication-failure trap is enabled. Version 1,2 notifications Target address____ Type Community___ ____Version Udp_____Filter ___port_____name sec To_____Retries Version 3 notifications Target address___Type Level Username_______Security ____port_______name Udp_____Filter sec To_____Retries SystemContact: System Location: ENWW Configuration Overview 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
To configure SNMP station IP address and community string(s), perform the following:
1.
At the console prompt, type
Enable
.
The prompt is displayed as #.
2.
Type
configure
and press
Enter
.
3.
In configuration mode, type the SNMP configuration command with the parameters including
community name (private), community access right (read and write) and IP address, as shown in
the following example:
console>
enable
console#
configure
config(config)#
snmp-server community private rw 192.168.1.2
config(config)#
exit
console(config)#
show snmp
Community-String
Community-Access
View Name
IP address
-------------------
-------------------
-------------------
private
readWrite
default
192.168.1.2
Community-String
Group name
IP address
Type
Traps are enabled.
Authentication-failure trap is
enabled.
Version 1,2 notifications
Target address____ Type
Community___ ____Version
Udp_____Filter
To_____Retries
___port_____name
sec
----------------_____-----
------------_____------
----_______-----
--______--------
Version 3 notifications
Target address___Type
Username_______Security
Udp_____Filter
To_____Retries
Level
____port_______name
sec
----------------____---------
------------_______------
----_______-----
--_______--------
SystemContact:
System Location:
ENWW
Configuration Overview
19