HP Blackbird 002-01A HP Blackbird Gaming System - Upgrading and Servicing - Page 19
Holding the inlay near to the panel, slide the inlay toward the back of the chassis
View all HP Blackbird 002-01A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
2 On the right side of the chassis, do the following: CAUTION: To avoid damaging the inlay, do not pull out the inlay more than 2.54 cm (1 inch) away from the panel. a Slowly pull out the square-cornered edge of the inlay (O, near the rear of the chassis) to free the three snaps along the right side of the inlay. b Continue to slowly pull out the edge of the inlay to free the two columns of three snaps located on each side of the middle of the inlay. c Holding the inlay near to the panel, slide the inlay toward the back of the chassis to free it. d Set the inlay aside. O This completes the steps to remove the inlay. Continue with step 3 to access the SATA backplane. To install the inlay, see "Replacing the right side access" on page 18. Upgrading and Servicing Guide 15