HP Brocade 8/12c FICON Administrator's Guide v6.4.0 (53-1001771-01, June 2010) - Page 39
Configuring FICON CUP, switch in a DCX-4S is to not assign any ports with addresses 0xFE and 0xFF.
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Configuring FICON CUP 3 Configuring FICON CUP To set up FICON CUP, use the following procedure and be sure to perform the steps in the order indicated. 1. Connect to the switch and log in using an account assigned to the admin role. 2. Verify that the switch or director has been set up according to the instructions in "Configuring switched point-to-point FICON" on page 16 and if in a cascaded topology, "Configuring Cascaded FICON" on page 20. 3. For directors with at least 256 ports installed, use the portDisable command to disable ports 254 and 255. Refer to "Persistently enabling and disabling ports for CUP" on page 35 for more information and detailed instructions. Ports 254 and 255 are not supported in a CUP environment. After FMS mode has been successfully enabled, these two ports remain disabled and cannot be used either as an F_Port or an E_Port. Because these ports are not available after enabling FMS mode, you should first move any fiber connected to either of them to another free port. Ports 254 and 255 are defined on the enterprise-class platforms in slot/port notation as follows: • On a Brocade 48000 disable 10/30 and 10/31. • On a Brocade DCX Backbone disable 12/30 and 12/31 when Virtual Fabrics is not enabled or zero-based addressing is not used. These physical locations may be different in logical switches using zero-based addressing. The recommended best practice for a DCX is to create a logical switch that does not include ports assigned with addresses 0xFE and 0xFF. • On a Brocade DCX-4S disable the corresponding ports for addresses 0xFE and 0xFF when these ports are assigned to a logical switch. The recommended best practice for a logical switch in a DCX-4S is to not assign any ports with addresses 0xFE and 0xFF. NOTE You can only disable these ports if there is a card present in the slot. 4. Enter the ficonCupShow fmsmode command to verify if fmsmode is disabled. 5. Take the appropriate action based on whether FMS mode is enabled or disabled: • If FMS mode is disabled, proceed to step 6. • If FMS mode is enabled, disable it using the ficonCupSet fmsmode disable command. ATTENTION If FMS mode is already enabled, disabling it might be disruptive to operations because ports that were previously prohibited from communicating will be allowed to do so because prohibits are no longer enforced. You must disable FMS mode to continue setting up CUP. 6. Install a CUP license on the switch. For more information on installing a license, refer to the Fabric OS Administrator's Guide. FICON Administrator's Guide 27 53-1001771-01