HP Brocade 8/12c Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, - Page 567
SULB-1020, persists, contact your switch service provider.
![]() |
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 567 highlights
SULB-1020 8 Probable Cause The error may be caused by a blade initialization issue after the new firmware is downloaded and the blade is rebooted. The error may also be caused by an internal Ethernet issue or by a persistent storage failure. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1020 Message AUDIT, , [SULB-1020], ERROR, FIRMWARE, , , , New firmware failed to boot in slot . Probable Cause The BP blade should reboot with the new image, but is still running the old image. This error may indicate that the new image has not been loaded correctly to the specified blade. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1021 Message AUDIT, , [SULB-1021], WARNING, FIRMWARE, , , , Firmware is being downloaded to the blade in slot . Probable Cause Indicates that the firmware is being loaded to the specified blade. Recommended Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it Action finishes, run the firmwareShow command to verify the firmware versions. Severity WARNING SULB-1023 Message Probable Cause AUDIT, , [SULB-1023], WARNING, FIRMWARE, , , , The blade in slot has rebooted during firmwaredownload. The error may be caused by an unexpected disruption of the firmwareDownload command, for example, by powering off and on of the indicated BP blade in the middle of a firmwareDownload. The error may also be caused by persistent storage hardware failure or by a software error. Fabric OS Message Reference 515 53-1000600-02
![](/manual_guide/products/hewlettpackard-ae370a-brocade-error-message-reference-guide-v610-53100060002-2008-045ec43/567.png)