HP Brocade 8/24c Web Tools Administrator's Guide (53-1001772-01, June - Page 96
Enabling interoperability, For McDATA Fabric Mode and McDATA Open Fabric Mode
View all HP Brocade 8/24c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
DRAFT: BROCADE CONFIDENTIAL 4 Switch configurations for mixed fabrics Enabling interoperability When you configure interoperability, Web Tools verifies that the domain ID of the switch falls within the range for the interoperability mode you select. The domain ranges are: • The normal domain ID range is 1 through 239. • The McDATA Fabric mode and McDATA Open Fabric mode are calculated based on the offset selected. • Before making changes to the interoperability mode, Web Tools checks to see if the domain ID of the switch falls within the range. If not, a warning message prompts you to change the domain ID before enabling the interoperability mode. Perform the following steps to change the interoperability configuration. 1. Open the Switch Administration window. 2. Disable the switch, as described in "Enabling and disabling a switch" on page 40. NOTE You can change the interoperability configurations only to a disabled (offline) switch. You are only able to disable the switch if the Admin Domain you are logged into owns the switch. 3. Select the Configure tab. 4. Select the Interoperability subtab. 5. Select the required mode: • Brocade Native Fabric Mode • For McDATA Fabric Mode and McDATA Open Fabric Mode, you can select the offset value from the Domain Offset (Hex) / Domain ID (Hex) drop-down list. The available offset values are 0 (0x00), 32 (0x20), 64 (0x40), 96 (0x60), 128 (0x80), 160 (0xA0), and 192 (0xC0). McDATA Open Fabric Mode supports 239 (0xFF) also. 6. Click Apply. 68 Web Tools Administrator's Guide 53-1001772-01