HP Brocade BladeSystem 4/12 Brocade OS Command Reference Manual Supporting Fab - Page 123

defZone 2 defZone Sets or displays the default zone access mode. Synopsis defzone [--noaccess | --allaccess | --show] Description Use this command to display or set the Default Zone access mode. Setting the Default Zone mode will initialize a zoning transaction (if one is not already in progress), and create reserved zoning objects. A default zone controls device access when zoning is not enabled. When a user-specified zoning configuration is not enabled, Default Zone is in effect, allowing access to all devices. When a user-specified zone configuration is enabled, it overrides the Default Zone access mode. Operands This command has the following operands: --noaccess Sets the default zone access mode to No Access, initializes a zoning transaction (if one is not already in progress), and creates the reserved zoning objects equivalent to the following zoning commands: cfgCreate "d_efault_Cfg", "d_efault_Zone" zoneCreate "d_efault_Zone", "00:00:00:00:00:00:00:01" A cfgSave, cfgEnable, or cfgDisable command must be issued after issuing this command to commit the changes and distribute them to the fabric; for example: primaryfcs:admin> defzone --noaccess primaryfcs:admin> cfgsave --allaccess An audit log record will be generated for each use of this command. When No Access default zone is activated, the following conditions apply: • If the current effective zone configuration is disabled with the cfgDisable command, the local switch converts this command to the equivalent of cfgEnable d_efault_Cfg. • If zoning receives a cfgDisable command from a remote switch that does not support default zoning, zoning rejects the cfgDisable command in the second phase of RCS because the remote switch does not convert the cfgDisable command to cfgEnable d_efault_Cfg. Sets the default zone access mode to All Access, initiates a zoning transaction (if one is not already in progress), and deletes the reserved zoning objects by performing the equivalent to the following zoning commands: cfgDelete "d_efault_Cfg" zoneDelete "d_efault_Zone" A cfgSave, cfgEnable, or cfgDisable command must be performed subsequent to the use of this command to commit the changes and distribute them to the fabric. If a cfgSave is performed and the fabric is already in the No Access default zone state, a cfgDisable is sent to the fabric. For example: primaryfcs:admin> defzone --allaccess Fabric OS Command Reference 97 53-1000599-01