HP Brocade BladeSystem 4/24 HP StorageWorks B-series Data Center Fabric Manage - Page 36

Closed defect summary Solution Server Management Console (SMC) displays the Status of Services as Unknown even after the services are restarted. Fixed in DCFM 10.3.0 Historical Performance Data Collection uses a lot of memory and when it is enabled and run for an extended period of time, client performance Fixed in DCFM 10.3.0 is slow. Purging Performance Records takes a considerable amount of time, which affects the performance of the client. Purge must be optimized. Fixed in DCFM 10.3.0 Old performance records are not purged due to an aging failure, causing an increased database size. A manual purge is required. Fixed in DCFM 10.3.0 The Names dialog displays an invalid message and you cannot view all the imported names. Fixed in DCFM 10.3.0 The Historical Data Collection displays Disabled even after enabling it SAN-wide. Fixed in DCFM 10.3.0 nl Workaround prior to this version: nl Select Historical Data Collection > En- able SAN Wide. When several Threshold Policies are created, the scroll bar is missing and incorrect names are listed for Duplicate Policies. Therefore, you cannot view all Threshold Policies. Fixed in DCFM 10.3.0 nl Workaround prior to this version: nl Increase the dialog size to view the Threshold Policies and edit the name of the Duplicate Policies. Fabric Watch replication randomly fails, requiring you to configure the policies in the individual switches. Fixed in DCFM 10.3.0 An inaccurate error message is displayed when you attempt to enable Top Talkers in switches running firmware earlier than V6.2. Fixed in DCFM 10.3.0 If more than one port is selected in the Available or Selected panel, clicking Port Picker Find does not display all selected ports. Fixed in DCFM 10.3.0 nl Workaround prior to this version: nl Select and find one port at a time. The Historical Report Destination column is blank for an F_Port connected to an Access Gateway switch. You cannot view the destination of Fixed in DCFM 10.3.0 the F_Ports. When Data Aging values are changed on the Server Management Console (SMC) tab, aging cleans up the data in the 5-minute table, but not in the 30-minute, 2-hour, or 1-day tables. Fixed in DCFM 10.3.0 If you create a logical switch by clicking New Switch in the Logical Switches window, Allow XISLs on the new logical switch is set to OFF, but should be ON by default. You cannot create XISLs while creating the logical switch in this manner. If you use the CLI to create the logical switch, Allow XISLs is ON by default. Fixed in DCFM 10.3.0 If after creating four virtual fabrics on an HP StorageWorks 8/80 SAN Switch, you delete the fourth one from the Logical Switches window, and then attempt to create a new one, the attempt fails with a Max# of logical switches is present on the switch error message. Fixed in DCFM 10.3.0 36