HP CB514A#ABA HP LaserJet P4010 and P4510 Series - User Guide - Page 169
Size Mismatch In Tray <xx>, Too Many S In Job To Finish
View all HP CB514A#ABA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Table 10-1 Control-panel messages (continued) Control panel message Description Recommended action RFU LOAD ERROR SEND FULL RFU ON An error occurred during a firmware upgrade. Contact an HP-authorized service or support PORT provider. ROM DISK DEVICE FAILURE The specified device has failed. Press OK to continue. To clear press OK ROM DISK FILE OPERATION FAILED A command attempted an illogical operation. Press OK to continue. To clear press OK ROM DISK FILE SYSTEM IS FULL To clear press OK The specified file system is full and cannot be Press OK to continue. written to. ROM DISK IS WRITE PROTECTED The device cannot be written to. Press OK to continue. To clear press OK SANITIZING DISK % COMPLETE A hard disk is being sanitized. No action is necessary. Do not power off alternates with CLEANING DISK % COMPLETE For help press SIZE MISMATCH IN TRAY For help press alternates with Current status message The tray indicated is loaded with a different size of paper than the size configured for the tray. Load the tray with the size configured for the tray. Make sure that the guides are positioned correctly in the specified tray. Printing can continue from other trays. Sleep mode on The product is in Sleep mode. No action is necessary. STAPLER LOW ON STAPLES For help press Fewer than 70 staples remain in the optional Replace the staple cartridge. For information stapler/stacker cartridge. Printing continues about replacing the staple cartridge, see until the cartridge runs out of staples. Load staples on page 120. alternates with READY To enter menus, press OK SUPPORTED HOST USB DEVICE DETECTED BUT INACCESSIBLE For help press A USB device has been detected. The product does not support plug and play operation. Turn the product off and then on, but do not unplug the USB device. TOO MANY PAGES IN JOB TO FINISH For help press The finishing device received too many pages to perform finishing. Pages will eject without finishing. Reduce the number of pages. TOO MANY PAGES IN JOB TO STAPLE For help press The maximum number of sheets the stapler For print jobs that have more than 15 pages, can staple is 15. The print job finishes printing staple them manually. but is not stapled. TOO MANY PAGES TO BIND For help press Too many pages were sent with the job. Binding cannot be completed. Reduce the number of pages. ENWW Interpret control-panel messages 157