HP CP4525dn HP Color LaserJet Enterprise CP4020/CP4520 Series Printer - User G - Page 51
Data Path Test, Execution Time
UPC - 884420585534
View all HP CP4525dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Table 2-1 Embedded Jetdirect menu (continued) Item Sub-item Sub-item SNMP TEST Sub-item YES NO* DATA PATH TEST YES NO* SELECT ALL TESTS YES NO* EXECUTION TIME [H] PING TEST EXECUTE YES NO* DEST TYPE DEST IPV4 DEST IPV6 PACKET SIZE IPV4 IPV6 TIMEOUT COUNT Description This test checks operation of SNMP communications by accessing predefined SNMP objects on the product. Select YES to choose this test, or NO to not choose it. This test helps to identify data path and corruption problems on an HP postscript level 3 emulation product. It sends a predefined PS file to the product, However, the test is paperless; the file will not print. Select YES to choose this test, or NO to not choose it. Use this item to select all available embedded tests. Select YES to choose all tests. Select NO to select individual tests. Use this item to specify the length of time (in hours) that an embedded test will be run. You can select a value from 0 to 24 hours. If you select zero (0), the test runs indefinitely until an error occurs or the product is turned off. Data gathered from the HTTP, SNMP, and Data Path tests is printed after the tests have completed. NO: Do not initiate the selected tests. YES: Initiate the selected tests. This test is used to check network communications. This test sends link-level packets to a remote network host, then waits for an appropriate response. To run a ping test, set the following items: Specify whether the target product is an IPv4 or IPv6 node. Type the IPv4 address. Type the IPv6 address. Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048. Specify the length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100. Specify the number of ping test packets to send for this test. Select a value from 0 to 100. The default is 4. To configure the test to run continuously, select 0. ENWW Control panel menus 37